What to do if Windows does not start

Sometimes problems can occur when starting a computer with a Windows operating system, here are the main causes and how to solve them

Sometimes it can happen that our computer with the Windows operating system has problems starting. It may happen, for example, that we cannot access the login page or that every time we turn it on, the PC takes us back to the start menu One of the most common cases on Windows is that the computer on restart instead of activating normally takes us back to the start menu section each time. To solve this problem the operations to be performed are not very complicated but the time at our disposal must be long enough. It may take a few minutes to complete the process but it could also take a couple of hours. This depends on why Windows instead of booting takes us to the boot settings. The problem in these cases is that it will also be impossible to access the provisional mode. This means that if we urgently need to use the computer, we must solve the problem first. Try every form of a startup: Before "tweaking" in the settings we try to start the PC in any way possible. To verify that in all cases the normal ignition fails. So let's try a classic start with the power button. Then with Safe Mode and then from the start menu. If any attempt fails it is very likely that one or more files were damaged during the last open session. These are fundamental documents for the correct switching on of the device and therefore the PC fails to start normally. In this case, to solve each problem, we need to perform a Windows installation restore. On Windows 10, just look for the Startup Restore item in the start menu. The same tool also exists on Windows 8, 7 and Vista. System recovery: If recovery at startup does not solve our problems, we will have to restore the system. This solution would solve any problem related to a damaged driver. Performing a system restore every document or driver will be restored when the PC is working properly. If we did not have the Windows 10 disk it is advisable to perform a restore from a CD, previously saved. The advice is to perform this operation as a precaution before the occurrence of bugs and problems with the device. Here's how to do a recovery disk. Not to be confused with a restore point. Repair protected files: A damaged system file may prevent any boot form. To overcome this problem we will have to use the control system file command to repair damaged Windows files. It must be said that SFC Command is not advisable for those who do not have great computer skills and are not familiar with the command prompt. Clear the CMOS: A BIOS configuration error could be one of the causes of boot bugs. To solve this type of problem, just clear the BIOS memory on the motherboard to restore all settings to factory default levels. If the PC is over three years old or has been off for months and months, the advice is to change the CMOS battery. If these have malfunctioned, in fact, it is normal for Windows to have problems at startup. Fortunately, these batteries are cheap enough and easy to find. Test the RAM: If the computer has problems with the RAM it may not turn on or work only up to the login screen and then restart or shut down. In this case, we will have to replace the RAM. The cost of RAM is not too high but we are very careful about the compatibility with our computer, otherwise, we will have made a useless purchase. Test the hard drive: As well as RAM, even the hard disk can be one of the reasons why our computer fails to boot properly. Furthermore, a hard drive problem will not even allow us to use a safe mode. The advice, in this case, is to replace the hard disk of Laptop or computer.